SFP_UDPONTRIG - SFP UDP on trig Module

This module, when started, can generate UDP broadcast frames on the rising edge on input trigger. The IPv4 ICMP ping protocol is also implemented in this module which can accept 0 to 256 Bytes ICMP payload size.

Fields

Name	Type	Description
SFP_TRIG	bit_mux	Rising edge ticks the sending of UDP user-defined frame
SFP_START_COUNT	write action	Start counting SFP_TRIG Rising edge from zero and send UDP user-defined frames
SFP_STOP_COUNT	write action	Stop counting SFP_TRIG Rising edge and stop sending UDP user-defined frames
SFP_DEST_UDP_PORT	param uint 131071	Destination UDP Port (16 bits integer value)
SFP_OUR_UDP_PORT	param uint 131071	Source UDP Port (16 bits integer value)
SFP_DEST_IP_AD_BYTE1	param uint 255	Destination ip address byte 1 (byte integer value) ip=BYTE1.BYTE2.BYTE3.BYTE4
SFP_DEST_IP_AD_BYTE2	param uint 255	Destination ip address byte 2 (byte integer value) ip=BYTE1.BYTE2.BYTE3.BYTE4
SFP_DEST_IP_AD_BYTE3	param uint 255	Destination ip address byte 3 (byte integer value) ip=BYTE1.BYTE2.BYTE3.BYTE4
SFP_DEST_IP_AD_BYTE4	param uint 255	Destination ip address byte 4 (byte integer value) ip=BYTE1.BYTE2.BYTE3.BYTE4
SFP_OUR_IP_AD_BYTE1	param uint 255	Our source ip address byte 1 (byte integer value) ip=BYTE1.BYTE2.BYTE3.BYTE4
SFP_OUR_IP_AD_BYTE2	param uint 255	Our source ip address byte 2 (byte integer value) ip=BYTE1.BYTE2.BYTE3.BYTE4
SFP_OUR_IP_AD_BYTE3	param uint 255	Our source ip address byte 3 (byte integer value) ip=BYTE1.BYTE2.BYTE3.BYTE4
SFP_OUR_IP_AD_BYTE4	param uint 255	Our source ip address byte 4 (byte integer value) ip=BYTE1.BYTE2.BYTE3.BYTE4
SOFT_RESET	write action	block Soft Reset
SFP_TRIG_RISE_COUNT	read	Rising edge count of SFP_TRIG
SFP_COUNT_UDPTX_ERR	read	UDP TX ERROR count
SFP_STATUS_COUNT	read	block counting status (‘0’ => standby, ‘1’ => counting enabled)
SFP_LOS	read	Loss-Of-Signal status (read from SFP module)
SFP_MAC_LO	read	MAC low in integer value bit 23:0
SFP_MAC_HI	read	MAC high in integer value bit 47:24